你知道在制造这些辐射水平配件时，山东电缆桥架的外部不会被切割。只切断电缆桥架的底部和内侧。将两根横向线之间的纵向线剪开，在弯道的底部和内部。当移除超过2”的线时，每增加一排时，将取下一根横向导线。一旦适当的行数被移除，内部的电线就被拉在一起，用剪接夹子连接起来。

　　You know that in the manufacture of these radiation level accessories, the outside of Shandong cable bridge will not be cut. Only cut off the bottom and inside of the cable bridge. Cut the longitudinal line between the two transverse lines at the bottom and inside of the bend. When more than 2 "lines are removed, a transverse wire is removed for each additional row. Once the appropriate number of rows is removed, the internal wires are pulled up and connected with a splice clip.

　　对于非径向水平弯曲，只需从相邻的电缆托盘电线的一侧，并将一个托盘在另一个之上，以便他们可以连接使用水平弯曲连接套件(第#SFS-HWB2部分)。这些托盘需要从垂直件的角上移开。水平三通和十字-当做三通或十字时，垂直底部可能向上。

　　For non-radial horizontal bending, simply from one side of the adjacent cable tray wire and place one tray above the other so that they can connect to the horizontal bend connection kit (part # SFS-HWB2). These pallets need to be removed from the corners of the vertical parts. Horizontal three-way and cross-when used as a three-way or cross, the vertical bottom may be upward.

　　在这种情况下，从所有相交的角上移除一侧块，从而使三通连接器可以形成一个辐射状的角。如果垂直构件重叠，底部有一个正方形，则需要从垂直件的角上移除两个部分。垂直弯曲-垂直弯曲是通过切割上部电缆托盘电线和弯曲的线篮和网目向上或向下。

　　In this case, the side block is removed from all intersecting corners so that the three-way connector can form a radiating angle. If the vertical component overlaps and there is a square at the bottom, you need to remove two parts from the corner of the vertical part. Vertical bending-Vertical bending is done by cutting the upper cable tray wire and curved wire baskets and mesh up or down.

　　总的来说，山东电缆桥架需要进行区分，选择适合的安装方式，从而事半功倍，欢迎大家前来http://www.sxdlqj.com/product咨询考察

相关文章：山东电缆桥架